Description

E2U Acrylic Sealer is formulated with aliphatic polymers using fast drying solvents. Properly applied, E2U Acrylic Sealer dries to a clear, abrasion resistant film which provides a weatherproof, sealer that is resistant to the sun, moisture, industrial chemicals, oil, grease, and most caustic cleaning agents. Test for solvent resistance. E2U Acrylic Sealer will extend the surface life to organic surfaces. When properly applied, its exceptional penetrating properties will seal concrete and other surfaces keeping them easy to clean and maintain. Regular cleanup and maintenance procedures can be easily implemented. E2U Acrylic Sealer will not yellow and will enhance the natural color of concrete. Multiple coats will increase the gloss to desired level. Areas showing excessive wear can be re-coated when desired.

Physical Properties

Volumetric Ratio: . . . . . . . . . . . . . . . . Single Component
Solids: . . . . . . . . . . 26% (+ or – 1%)
Coverage: . . . . . . . . . . 200-300 SF/gal.
Application Slab Temperature: . . . . . . . 55-95°F
Thinning . . . . . . . . . . . . . . . . Not Required

Applications

For use over Stone, Concrete floors, driveways and other natural surfaces where high quality, light stable sealing requirements are mandatory.

Concrete Preparation

Surfaces to be sealed must be clean, dry, and free of oil, stains and silicone compounds. Do not apply E2U Acrylic Sealer until all traces of curing compounds have been completely dissipated. Substrate to be coated must be moisture free. Dries to touch in 30 minutes and may be opened to normal traffic after 2 hours, heavy traffic after 24 hours. Do not apply if air temperature and/ or temperature of substrate are less than 50 degrees F. Excellent for use over colored concrete, expect a slight color change. E2U Acrylic Sealer will enhance colors. Always, do a test panel for approval.
DISARM ALL SPRINKLER SYSTEMS 48 HOURS PRIOR TO APPLICATION AND DURING CURE TIME.

Application Instructions

E2U Acrylic Sealer may be applied by a brush, roller, lamb’s wool applicator or industrial sprayer. Avoid any excessive buildup or puddling of product. E2U Acrylic Sealer may be applied in multiple coats to achieve desired degree of protection and gloss.

Physical Properties

Boiling Point: Over 285° F
Evaporation Rate: Less than 1 (n-Butyl Acetate = 1)
% Volatile by Weight: 38-49(Theoretical)
Vapor Density: Not Determined

Hazardous Components

Coverage

Approximately 200 – 300 sq. ft. per gallon, depending on substrate and application method.
Note: Test a small area before applying. NEVER THIN MORE THAN 10% BY VOLUME USING ACETONE!

Safety

Use only in well ventilated areas. Always use gloves, protective eyewear and clothing. Overexposure to this product may cause SERIOUS HEALTH RISKS. If ingested do not induce vomiting, call a physician immediately.

Clean Up

Equipment should be immediately cleaned with Acetone.

Warranty
E2U products are warranted for one year after date of application. Please refer to the Limited Material warranty for additional clarification.

Datasheet & MSDS

Solvent Sealer Data Sheet

Solvent Sealer MSDS Part A

Solvent Sealer MSDS Part B